Skip to content
HVS-2767.Three phase transmission line fault detection and analysis system Using Arduino.
HVS-2767.Three phase transmission line fault detection and analysis system Using Arduino.
HVS-2767.Three phase transmission line fault detection and analysis system Using Arduino.
HVS-2767.Three phase transmission line fault detection and analysis system Using Arduino.

HVS-2767.Three phase transmission line fault detection and analysis system Using Arduino.

₹14,000.00

The main aim of this project is to design a three phase fault detection using an Arduino UNO and display the fault type on LCD module.This system detects four types of faults line-line fault, line -line to ground fault, line to line-line.

Category Tags , , , 
The main aim of this project is to design a three phase fault detection using an Arduino UNO and display the fault type on LCD module. This system detects four types of faults line-line fault, line -line to ground fault, line to line-line. This proposed model uses the concept of Ohms law to detect the open circuit fault, line-line fault and line to line line, line –mine ground which is quick, reliable and cost effective. GPS plays a crucial role in this project that retrevies location data ,allowing precise tracking of the system’s fault locations. This system consists of ESP8266 WI-FI module to send the data through IOT to smart mobiles. If any abnormal condition in system it will alerts the user through buzzer. This system uses an Arduino microcontroller and a rectified power supply. Here the current sensing circuits made with a switches combination of resistors are interfaced to Arduino micro controller at ADC port for providing digital data to the microcontroller representing the cable length in kilometers. At every known kilometer fault switches are placed to create faults manually, hence the fault is detects ,gps tracker locates the exact location of the fault and display on LCD module and activate buzzer for alerts. The fault creation is made by the set of switches. Whenever a fault occurs in a cable then it will trip the circuit through Relay. If there is no fault then led will off and relay will be in on position.  

Objectives:
  • Design a three phase fault analysis system.
  • It will detect line-line, open circuit line to ground faults.
  • Sensor based smoke sensing circuit.
  • R,Y,B fault indication using Bulbs.
  • Audible alerts using BUZZER.
  • Visible alerts using LCD display.
  • GPS to track the locations.
 

The major building blocks of this project are:

 
  • Adapter power supply.
  • Arduino UNO Microcontroller.
  • Fault switches.
  • Resistor
  • Relay
  • LCD with driver.
  • Esp8266 Wi-Fi module.
  • Buzzer
  • Three phase supply.
  • GPS
  Software’s used:  
  • Arduino IDE for compiling and dumping code into Microcontroller
  • Express SCH for Circuit design.
     

Block diagram:

video:

Related Products